Services

Design Tools

Power, Flow and Temperature

Power kW

,000 Btus / H

  • -

Temperature Rise The difference between the incoming mains temperature and the water coming out of taps.

°C

  • -

Flow Rate

litres/minute

  • -

Cylinder Sizes

This tool shows the range of cased hot water cylinder sizes that Thermal Integration can supply. We offer four diameters providing a great deal of flexibility if needed. Bear in mind that the 530 diameter is the standard, with other diameters costing more.

Unit Type

Tube Cylinder Combi Pandora

litres

85 100 130 140 150 180 210 250 300 350 400 450 500

1990mm250litres

1572mm250litres

1274mm250litres

885mm250litres

400mm 450mm 500mm 600mm

Storage Capacity Calculator

This tool provides a simple method of working out the volume of hot water storage that is required. The figures are based on standard systems. Click on each type of outlet to add the required number. Ideally used for estimating the size of HEATBANK® Thermal Store required. For further assistance, please telephone Thermal Integration on 0845 241 1411.

For use estimating the size of HEATBANK® Thermal Store


Extra large bath 0

Bath (full to overflow) 0

Bath 0


Drench shower 30lpm 5min 0

Rain shower 20lpm 5min 0

Shower 12lpm 5min 0


Basin 0

Sink 0

RESET

Run Period

mins

  • -

Incoming Mains Temp

°C

  • -

Storage Temperature Drop

°C

  • -

Boiler Input

kW

  • -

Store Capacity

litres

Expansion Vessel Sizing

A simple way to work out the size of the central heating expansion vessel required for certain sized systems.

The system fill pressure is typically near or above the expansion vessel pre-charge pressure which must be enough to fill the system to the highest point , where 10m=1bar.

The maximum pressure should be below the setting of the pressure relief valve on the system.

For use in sizing expansion vessels for sealed heating / primary systems. For further assistance, please telephone Thermal Integration on 0845 241 1441.

System Volume

litres

  • -

System Fill Pressure

bar

  • -

Maximum Pressure

bar

  • -

Saving Each Load

litres

Energy Storage

For use in sizing stores to drive heating systems. For further assistance, please telephone Thermal Integration on 0845 241 1441.

This tool is a simple method of working out the volume of hot water storage that is required to provide storage heating.

Power kW ,000 Btus / H

  • -

Temperature Rise °C

  • -

=

Flow Rate l/sec l/min


Duration mins

  • -

=

Energy kWh Volume litres


Fuel Rate 1 p/kWh

  • -

Fuel Rate 2 p/kWh

  • -

=

Cost 1 Cost 2

Difference

Power & Flow, Loading Calculator

The following tools are built with Flash and will not work on all devices.

Converted from the previous website, last edited 2023-11-09. Under review for the new site.

Talk to an engineer

Tell us about your network and we will come back with a practical next step, usually within one working day.