Heatbank Xcel Installation and User Instructions

This page is currently a Work In Progress. May 2018.

This page is intended to form a repository of information intended to form a kernel of content that will ultimately lead to an up to date set of Installation and User Instructions for the Xcel.

Introduction

Congratulations on your purchase of the Xcel Heat Bank® Thermal Store. The Xcel is manufactured in the UK from high quality Duplex stainless steel offering exceptional strength and corrosion resistance, back up by a lifetime guarantee. The insulation levels of the cylinder meet the requirements of Building Regulations Part L.

The Xcel store is intended to permit a variety of different heat sources to contribute towards the provision of domestic hot water (DHW) and central heating in your property. The store is not a heating appliance in its own right and is reliant on the appliances that are connected to it to deliver the energy required to support your hot water and heating requirements. It is therefore important that those heating appliances are correctly rated for the size and configuration of the Xcel store they will connect to, and for the heating and hot water demands of the property it is installed in.

The Xcel store is manufactured in a number of different variants and your unit will be supplied in a specification matching those requirements given to Thermal Integration by the purchaser at the time the unit was ordered. The following set of installation and user instructions are tailored towards that specification. If your system has a different specification, or you require information on other variants available, please contact Thermal Integration Ltd. (Tel: 0845 2411441).