Balancing of Central Heating Systems

The job of balancing radiators properly appears to have become a dark and forgotten art, despite the fact it remains the key to an efficient system. Certainly if using condensing boilers, heat pumps, or district heating it is most likely to be one of the main causes of inefficiency if not addressed properly.

This article will cover the best practices for the installation and balancing of radiator systems in modern properties, with the aim of achieving low return temperatures - the key to efficiency.

Flow rates in modern properties

When the book was written on balancing systems, heating loads were significantly higher, and the issue of designing for low flow conditions was not as important as it is now. Where before one would be designing at 10kW plus, you now need to ensure systems work well at loads under 2kW.

There have also been changes in pump and valve technology that change the playing field. These low flow rates make balancing a system using traditional radiator valves almost impossible, and it is important to look at the latest technology that is been used to control at these lower flow rates.

By-passes and towel rails

As far as we are concerned, it is a cardinal sin of plumbing to have open or uncontrolled by-passes on heating systems. Towel rails are the most common culprit, not been fitted with a TRV or properly balanced, they just let hot primary flow water into the return pipework, destroying decent return temperatures.

By-passes are often excused on the basis of protecting a pump from a dead heat situation, especially when using zoned control. Modern self regulating pumps can wind themselves down and will not incur damage from short periods against valve closure. Furthermore, they can be protected with an auto-bypass valve that will only open when needed.

kW, Delta T, Flow Rate, Kv and DP

These absolutely must be understood by anyone taking any responsibility for the selection of equipment used in heating systems. Almost all heating calculations use these figures.

We start with the power output in kW. Such as a radiator load of 1.5kW

The Delta T refers to the change in temperature, and often referred to as the temperature drop, or rise. Measured in degrees C.

From the kW an Delta T we can work out the Flow Rate using the following equation:

 Flow Rate [litres/second] = kW / (4.2 x Delta_T)

Pump head settings

Modern pumps allow for low and constant head settings that in turn allow the use of larger bore TRVs.

If you think you can leave a pump on full setting against standard TRVs in a modern dwelling, then think again.

A modern pump generates up to 7 metres head.